What is the Oxy cutting?
Oxy cutting is also known as the oxy-fuel welding as well as oxyacetylene welding in United States. They are the processes which use fuel gases as well as oxygen in order to weld as well as cut metals. Edmond Fouche as well as Charles Picard was the first men who developed the idea of oxy-fuel welding during the year of 1903.
Why to adopt the oxy cutting processes?
If anyone wants to cut steels faster, than oxy cutting is the perfect gateway. Oxy cutting requires manual components which are not expensive. These are also portable, safe as well as versatile. Anyone may cut the thick as well as thin plates with the assistance of this merchandise system. These materials may be used for cutting rusty as well as scaled plate. Oxy cutting requires moderate skills.
Oxy cutting processes:
Here, pure oxygen is used, instead of the air and these are used to enhance the flame temperature in order to permit localized melting in the room environment. Here a common air-flame burns at around 3630 degree fahrenheit, propane-flame burns at around 4530 degree fahrenhiet. Oxy cutting is not a new welding process. It has been widely used in the industrial sector as well as many other devised technologies. It is also used as for running the welding process. Oxy cutting is also used for welding tubes as well as pipes. It best suits with fabricating metal based artwork.
Advantages of Oxy cutting:
Oxy-fuel has magnificent advantage over the electronic welding as well as cutting processes. It is also used at a certain place where electricity is hardly accessible. So, it may be told that this welding system as well as cutting process is self-contained as well as ‘More portable’. In oxy cutting, welding torches are used in order to weld metals. Welding metals are resulted when 2 pieces are provided heat in order to ensure the temperature which produces the shared pool required for the molten metals. Filler is the additional metal and it is supplied with the molten pool and those materials depend on the metals which are used to be welded. After heating the metals oxygen stream is trained on metals that results into the metal oxide and it flows out as slag. It is also known as the ‘Gas Axe’. Torches which cannot mix fuel including oxygen are not oxy-fuel torches and they may be identified by the single tank.
Safety issues:
Oxy cutting deserves a high risk of being burned. So, it’s important for a person to prevent the molten slag as well as sparks. One has to make sure that he is wearing gloves before Welding.
Required elements for Oxy cutting:
However, oxy-cutting requires 2 isolated supplies, oxygen as well as fuel. Most of the metals can hardly be melted. As for example anyone may use the single tank torch for executing the operation of soldiering as well as brazing.
Author Bio: Author is experienced and famous because of their expert opinion over the topic. He also wrote several poplar posts on oxy cutting similar to this.
