DIY Tips Included - WP8066184 8066184 Dryer Motor Pulley Replacement by PartsBroz

Posted by shahinc on February 21st, 2023

If your dryer has been making strange noises or has stopped working altogether, there's a good chance that the motor pulley needs to be replaced. The motor pulley is a crucial component of your dryer's motor system, responsible for turning the drum and powering the dryer's various functions. Fortunately, replacing the motor pulley is a relatively simple process that can be done with just a few tools and some basic knowledge. In this blog, we'll take you through the process of replacing the WP8066184 8066184 Dryer Motor Pulley, a popular replacement part from PartsBroz.

Why replace the motor pulley?

Before we dive into the replacement process, it's important to understand why you might need to replace the motor pulley in the first place. Over time, the motor pulley can wear down or become damaged, causing the dryer to make loud or unusual noises, or even preventing the dryer from working altogether. If you notice any of these symptoms, it's time to replace the motor pulley.

Getting started

To replace the motor pulley, you'll need a few tools and supplies:

• A replacement WP8066184 8066184 Dryer Motor Pulley from PartsBroz
• A screwdriver
• A socket wrench
• A pair of pliers
• A new belt (optional)

Step-by-step instructions

1. Unplug the dryer.

Before you begin, make sure the dryer is unplugged and disconnected from any power source. This is an important safety precaution that should never be skipped.

2. Access the motor.

To access the motor, you'll need to remove the dryer's front panel. This process may vary depending on the make and model of your dryer, so consult your owner's manual for specific instructions.

3. Remove the old motor pulley.

Once you've accessed the motor, locate the motor pulley. Use a socket wrench to remove the nut that holds the pulley in place, then use a pair of pliers to remove the pulley itself.

4. Install the new motor pulley.

Once the old pulley is removed, simply slide the new WP8066184 8066184 Dryer Motor Pulley from PartsBroz onto the motor shaft and secure it with the nut you removed earlier.

5. Reassemble the dryer.

With the new motor pulley in place, reassemble the dryer by replacing the front panel and reconnecting any electrical connections. If your old belt was worn, this is also a good time to replace it with a new one.

And that's it! With these simple steps, you can replace your dryer's motor pulley and get your dryer back in working order. Remember, always consult your owner's manual or a professional if you're unsure about any step in the process.